Steam Trap embedded in Pressure Reducing Valve.

Pressure Reducing Valve with Steam Trap.

Feature

It is very suitable to install at a place where drainage is easy to stay.
Preventing the drainage to go on secondary side in the control devices.
Preventing against the uncontrolled RP-6 by drainage at the beginning of steam blow.
End connection for drainage side can be turned 90-degree, and easy to connect with pipe.
Possible to add the Steam trap part to RP-6 already installed for sizes 15mm to 50mm.

RP-6BD

RP-6

Pressure reducing valve part	Model	RP-6BD
	Size	15 - 50
	Applicable fluid	Steam
	Applicable temperature	Max. 184 Deg.C
	Applicable primary pressure	Max. 1.0MPa
	Adjustable secondary pressure	0.03 - 0.8 MPa
	Maximum reducing rate	20 : 1
	Minimum pressure differential across the disc	0.05 MPa
	Lock up pressure	0.02 MPa
	Offset pressure	Within 0.02 MPa (Adjustable secondary pressure) Within 0.03 MPa (Adjustable secondary pressure) Within 0.05 MPa (Adjustable secondary pressure)
	Leakage allowance	Less than 0.05% of rated flow
	End connection	Flanged JIS 10KFF
	Materials	Body(Cast iron), Disc & Seat(Stainless steel), Diaphragm(Stainless steel)
	Valve body pressure test	Hydraulic 1.5MPa
Steam trap part	Type	Disc type
	Applicable pressure	Max. 1.0 MPa
	Allowable back pressure	Within 70% of inlet pressure.
	Max. continual discharge amount.	See table below

Dimensions

Size	L	G	H	H1	A	Cv	Weight(kg)
15	190	135	155	72	1/2	1	10
20	190	135	155	72	1/2	2.5	10
25	150	190	160	77	1/2	4	11.5
32	180	151	182	88	3/4	6.5	14.5
40	180	151	182	88	3/4	9	15
50	200	166	187	98	3/4	16	18.5

Constructions

Max. continual discharge amount.

Pressure differential (MPa)	0.05	0.1	0.2	0.3	0.4	0.6	0.8	1.0
Discharge amount (l/h)	100	160	260	340	400	500	550	590